Optical-microwave sensor for real-time measurement of water contamination in oil derivatives Articles uri icon

authors

  • ABDULSATTAR, RUSUL KHALID
  • ALIBAKHSHIKENARI, MOHAMMAD
  • VIRDEE, BAL S.
  • SHARMA, RICHA
  • Elwi, Taha A.
  • Kouhalvandi, Lida
  • ABDUL HASSAIN, ZAID A.
  • ALI, SYED MANSOOR
  • TÜRKER TOKAN, NURHAN
  • Livreri, Patrizia
  • FALCONE, FRANCISCO
  • LIMITI, ERNESTO

publication date

  • October 2023

start page

  • 1

end page

  • 10

issue

  • 154798

volume

  • 170

International Standard Serial Number (ISSN)

  • 1434-8411

Electronic International Standard Serial Number (EISSN)

  • 1618-0399

abstract

  • This paper presents a novel microwave sensor using optical activation for measuring in real-time the water contamination in crude oil or its derivatives. The sensor is constructed from an end-coupled microstrip resonator that is interconnected to two pairs of identical fractal structures based on Moore curves. Electromagnetic (EM) interaction between the fractal curves is mitigated using a T-shaped microstrip-stub to enhance the performance of the sensor. The gap in one pair of fractal curves is loaded with light dependent resistors (LDR) and the other pair with microwave chip capacitors. The chip capacitors were used to increase the EM coupling between the fractal gaps to realize a high Q-factor resonator that determines the sensitivity of the sensor. Empirical results presented here show that the insertion-loss of the sensor is affected by the change in LDR impedance when illuminated by light. This property is used to determine the amount of water contaminated oil. The sensitivity of the sensor was optimized using commercial 3D EM solver. The measurements were made by placing a 30 mm diameter petri dish holding the sample on top of the sensor. The petri dish was filled up to a height of 10 mm with the sample of water contaminated crude oil, and the measurements were done in the range between 0.76 GHz and 1.2 GHz. The Q-factor of the oil sample with no water contamination was 70 and the Q-factor declined to 20 for 100% contamination. The error in the measurements was less than 0.024%. The sensor has dimensions of 0.127λo × 0.127λo × 0.004 λo and represents a new modality. Compared to existing techniques, the proposed sensor is simple to use, readily portable and is more sensitive.

subjects

  • Computer Science
  • Mechanical Engineering
  • Physics
  • Telecommunications

keywords

  • electromagnetic (em) spectrum; fractal curves; light dependent resistors (ldr); microstrip sensor