A Soft-Switching Blind Equalization Scheme via Convex Combination of Adaptive Filters Articles uri icon

publication date

  • March 2013

start page

  • 1171

end page

  • 1182

issue

  • 5

volume

  • 61

international standard serial number (ISSN)

  • 1053-587X

electronic international standard serial number (EISSN)

  • 1941-0476

abstract

  • Blind equalizers avoid the transmission of pilot sequences, allowing a more efficient use of the channel bandwidth. Normally, after a first rough equalization is achieved, it is necessary to switch these equalizers to a decision-directed (DD) mode to reduce the steady-state mean-square error (MSE) to acceptable levels. The selection of an appropriate MSE threshold for switching between the blind and the DD modes is critical to obtain a good overall performance; however, this is not an easy task, since it depends on several factors such as the signal constellation, the communication channel, or the signal-to-noise ratio. In this paper, we propose an equalization scheme that adaptively combines a blind and a DD equalizers running in parallel. The combination is itself adapted in a blind manner, and as a result the overall scheme can automatically switch between the component filters, avoiding the need to set the transition MSE level a priori. The performance of our proposal is illustrated both analytically and through an extensive set of simulations, where we show its advantages with respect to existing hard-and soft-switching equalization schemes.

keywords

  • adaptive filters; equalisers; mean square error methods; telecommunication channels