Outputs for THERMAL AND FLUIDS ENGINEERING Department (Year 2021)
|
Articles
- Assessment of the time resolution used to estimate the central solar receiver lifetime
- Calculating molten-salt central-receiver lifetime under creep-fatigue damage
- Carbon footprint and water use of alkali-activated and hybrid cement mortars
- Defining the cost of water impact for thermoelectric power generation
- Deformation and breakup of bubbles interacting with single vortex rings
- Dip-coating flow in the presence of two immiscible liquids
- Direct solar air heating inside small-scale linear Fresnel collector assisted by a turbocharger: Experimental characterization
- Dual-tower CSP plants: optical assessment and optimization with a novel cone-tracing model
- Economic analysis of a zero-water solar power plant for energy security
- Economic and thermo-mechanical design of tubular sCO2 central-receivers
- Effects of the diffusive mixing and self-discharge reactions in microfluidic membraneless vanadium redox flow batteries
- Efficiency enhancement of gas turbine systems with air injection driven by natural gas turboexpanders
- Energy recovery through co-pyrolysis of wastewater sludge and forest residues - The transition from laboratory to pilot scale
- Evaluation of the number of first-order reactions required to accurately model biomass pyrolysis
- First demonstration of the use of crab cavities on hadron beams
- Flame initiation near a cold isothermal wall: Ignition by an instantaneous thermal dipole
- How to make sustainable CO2 conversion to Methanol: Thermocatalytic versus electrocatalytic technology
- Influence of immersed surface shape on the heat transfer process and flow pattern in a fluidized bed using numerical simulation
- Introduction to an exergy-based socioeconomic analysis
- Jamaican bioethanol: an environmental and economic life cycle assessment
- Lubrication analysis of peristaltic motion in non-axisymmetric annular tubes
- Material selection for solar central receiver tubes
- Micro-combustion modelling with RBF-FD: A high-order meshfree method for reactive flows in complex geometries
- Modeling gas diffusion layers in polymer electrolyte fuel cells using a continuum-based pore-network formulation
- Modeling the Effect of Low Pt loading Cathode Catalyst Layer in Polymer Electrolyte Fuel Cells. Part I: Model Formulation and Validation
- Modeling the motion of fuel particles in a fluidized bed
- Non-linear dynamics and self-similarity in the rupture of ultra-thin viscoelastic liquid coatings
- Novel insights in dimethyl carbonate-based extraction of polyhydroxybutyrate (PHB)
- Numerical analysis of the autoignition of isolated wet ethanol droplets immersed in a hot and humid air atmosphere
- Numerical and Experimental Evaluation and Heat Transfer Characteristics of a Soft Magnetic Transformer Built from Laminated Steel Plates
- Numerical description of axisymmetric blue whirls over liquid-fuel pools
- Numerical simulation of a 3-D gas-solid fluidized bed: Comparison of TFM and CPFD numerical approaches and experimental validation
- On the Conductivity of Proton-Exchange Membranes Based onMultiblock Copolymers of Sulfonated Polysulfoneand Polyphenylsulfone: An Experimental and Modeling Study
- Optimization of Water Pressure of a Distribution Network within the Water-Energy Nexus
- Performance of a shallow solar pond coupled with a heat pump cycle for thermal energy in net zero-energy buildings
- Process design and thermoeconomic evaluation of a CO2 liquefaction process driven by waste exhaust heat recovery for an industrial CO2 capture and utilization plant
- Recycling CO2from flue gas for CaCO3nanoparticles production as cement filler: A Life Cycle Assessment
- Sistema de producción de la almendra y del cacao: una caracterización necesaria
- Small-scale linear Fresnel collector using air as heat transfer fluid: Experimental characterization
- Solar and biomass hybridization through hydrothermal carbonization
- Solid phase adsorption method for tar sampling - How post sampling treatment affects tar yields and volatile tar compounds?
- Specific heat effects in two-dimensional shock refractions
- Stability of expanding accretion shocks for an arbitrary equation of state
- Stability of laminar flames on upper and lower inclined fuel surfaces
- Superhydrophobic substrates allow the generation of giant quasi-static bubbles
- Synthesis, characterization and absorbability of Crocus sativus petals hydrothermal carbonized hydrochar and activated hydrochar
- Techno-economic assessment and optimization of a solar-assisted industrial post-combustion CO2 capture and utilization plant
- The influence of the elemental and structural chemical composition on the ash fusibility of sugarcane bagasse and sugarcane straw
- Theoretical and numerical analysis of the evaporation of mono and multicomponent single fuel droplets
- Thermal stress and fatigue damage of central receiver tubes during their preheating
- Thermochemical effects on hypersonic shock waves interacting with weak turbulence
- Transmantle pressure computed from MR imaging measurements of aqueduct flow and dimensions
- Turbo-assisted direct solar air heater for medium temperature industrial processes using Linear Fresnel Collectors. Assessment on daily and yearly basis
- Vibration augmentation of the solids volume dragged by the wake of a bubble rising in a fluidized bed
Conference Contributions
- Alluvial fan at Coprates Catena in Valles Marineris, Mars: new modeling insights
- Cratering processes on rubble-pile asteroids: Insights from laboratory experiments and numerical models
- Creep and fatigue damage assessment for molten-salt central receivers
- Influence of Layering and Boulder Inclusions in a Granular Target on Crater Formation: Insight from Laboratory and Numerical Studies.
- Influence of target heterogeneity on crater formation: Insight from laboratory and numerical studies
- Mathematical modelling of a membrane-less redox flow battery
- Numerical simulation of the electrolyte flow in the tanks of vanadium redox flow batteries
- Numerical simulation of the flow of a gas-particle dense suspension through a vertical tube for CSP applications
- Reconstructing a Martian channel-fan formation iteratively with mapping and mechanical modeling
- Stability of expanding accretion shocks in reactive media
- Stability of reactive shocks in the generalized Noh problem
- Superheater Design Assessment for Flexible Solar Tower Plants
- The Stokes and Euler regimes of thin film rupture
- Theoretical and numerical analysis of a membraneless redox flow battery
Projects
- Complex interfacial flows with applications to coatings, interfacial rheology, microemulsions, hydrogen generation, cavity implosions and drop impact on liquid films - II
- Contrato de suministro de 4 lotes vinculados a sistemas de evaluación de calidad: Lote 3. Reducción del residuo orgánico urbano en vertedero y posterior valorización
- Cálculo de eficiencias y viabilidad de sistema PLUVIO
- DESARROLLO DE SISTEMA PARA LA CONDENSACIÓN DEL VAPOR DE AGUA ATMOSFÉRICO
- Diseño termo-mecánico de un evaporador para hidrógeno líquido
- EUROFUSION Europe 2021-WPMAT: MAT-T.02.03-T001-D003-Development of 9-14 %Cr ODS for the fabrication of first wall components
- Estudio de las prestaciones de heat pipes porosas obtenidas mediante fabricación. aditiva
- Estudio experimental y teórico de la evaporación de gotas expiratorias que contienen coronavirus
- Evaluación del efecto del dispositivo Dispositivos de ahorro en la combustión OPTIGAS
- Modelado del flujo de líquido cefalorraquídeo en el canal espinal y sus implicaciones en enfermedades neurológicas
- Posicionamiento estratégico de la Comunidad de Madrid en I+D+I del hidrógeno verde y las pilas de combustible dentro del Plan Complementario de Energía e Hidrógeno Renovable en el marco del componente 17.
- Posicionamiento estratégico de la Comunidad de Madrid en I+D+I del hidrógeno verde y las pilas de combustible dentro del Plan Complementario de Energía e Hidrógeno Renovable en el marco del componente 17. UC3M
- Posicionamiento estratégico de la Comunidad de Madrid en I+D+I del hidrógeno verde y las pilas de combustible dentro del Plan Complementario de Energía e Hidrógeno Renovable en el marco del componente 17. UC3M
Supervised Theses
- Direct solar air heating in linear concentrating collectors assisted by a turbocharger for industrial processes: theoretical analysis and experimental characterization
- Dynamics of Complex Capillary Flows: Stability, Rupture, and Influence of Surfactants
- Optimization of Solar Thermal Plants: Transient Analysis and Design of Eccentric Bayonet Receivers
- Thermo-mechanical modelling to evaluate solar receiver damage