Outputs for THERMAL AND FLUIDS ENGINEERING Department (Year 2014)
|
Articles
- Bubble formation in a planar water-air-water jet: Effects of the nozzle geometry and the injection conditions
- CCD image sensor induced error in PIV applications
- Characterisation of the particle-wall frictional forces in pseudo-2D fluidized beds using DEM
- Characterization of the particle-wall frictional forces in pseudo-2D fluidized beds using DEM
- Comparison of simplified heat transfer models and CFD simulations for molten salt external receiver
- Effect of the equivalence ratio, Damköhler number, Lewis number and heat release on the stability of laminar premixed flames in microchannels
- Energy and exergy analysis of an adiabatic water-LiBr absorption system
- Evaluating the accuracy of the Distributed Activation Energy Model for biomass devolatilization curves obtained at high heating rates
- Experimental study on the motion of isolated bubbles in a vertically vibrated fluidized bed
- Feedback PID-like fuzzy controller for pH regulatory control near the equivalence point
- Global stability analysis of the axisymmetric wake past a spinning bullet-shaped body
- Global stability of stretched jets: Conditions for the generation of monodisperse micro-emulsions using coflows
- Linear theory for the interaction of small-scale turbulence with overdriven detonation
- Modeling of the anode of a liquid-feed DMFC: Inhomogeneous compression effects and two-phase transport phenomena
- Moving bed syngas conditioning: Modelling
- Moving bed syngas conditioning: Modelling
- PCM in the heat rejection loops of absorption chillers. A feasibility study for the residential sector in Spain
- Physics of Beer Tapping
- Physics of Beer Tapping
- Ray tracing of a solar collector designed for uniform yearly production
- Recent advances in understanding of flammability characteristics of hydrogen
- Regimes of spray vaporization and combustion in counterflow configurations
- Saving assessment using the PERS in solar power towers
- Simulation and experimental study on the motion of non-reacting objects in the freeboard of a fluidized bed
- Single-effect absorption refrigeration cycle boosted with an ejector-adiabatic absorber using a single solution pump
- Solar energy captured by a curved collector designed for architectural integration
- Solar-powered single-and double-effect directly air-cooled LiBr-H2O absorption prototype built as a single unit
- Techno-economic analysis of integrating sweet sorghum into sugar mills: The Central American case
- The chemistry involved in the third explosion limit of H₂-O₂ mixtures
- The differential diffusion effect of the intermediate species on the stability of premixed flames propagating in microchannels
- The effect of temperature on the distributor design in bubbling fluidized beds
- Thermal design guidelines of solar power towers
- Wall conduction effects in laminar counterflow parallel-plate heat exchangers
- Wide band energy analysis of fluidized bed pressure fluctuation signals using a frequency division method
Books
Conference Contributions
- A multipurpose reduced kinetic scheme for methanol combustion
- A sampling method to determine the terminal velocity and size distribution of fluidized nanopowder agglomerates
- An experimental and numerical study of flames in narrow channels with electric fields
- Bubble formation dynamics in a planar co-flow configuration: Influence of geometric and operating characteristics
- Buoyant Norbury's vortex rings
- Co-feeding of natural gas in pyrolysis plants producing biofuels: GHG savings and economic impact
- Dissolution of spherical cap CO2 bubbles attached to flat surfaces in air-saturated water
- Dripping dynamics at high Bond numbers
- Drop formation in gravitationally stretched Newtonian liquid jets: Experiments and global linear frequency response analysis
- Dynamics and agglomeration of a fluidized bed reactor under Cynara Cardunculus L. Gasification with a new catalyst (Sepiolite)
- Effect of an external electric field on the propagation velocity of premixed flames
- Effect of the injector geometry and the operation conditions on the bubble formation in a planar air-water coflow configuration
- Effect of the inlet gas humidification on PEMFC behavior and current density distribution
- Effect of the order of accuracy in the accurate runge-kutta scheme for the determination of the transient true void fraction and pressure drops in pipes
- Experimental and numerical analysis of the steady streaming around a cylinder pair
- Experimental evaluation of an ejector-adiabatic absorber with ammonia-lithium nitrate solution
- Experiments and non-parallel theory on the natural break-up of freely falling Newtonian liquid jets
- Global mode and frequency response analysis of low-density jets
- Global stability analysis of jet diffusion flames
- History effects on the diffusion-driven growth and dissolution of a gas bubble
- Linear stability of the flow around a spinning bullet-shaped body: global modes and sensitivity to base bleed
- Modal instability analysis of low-density jets
- Modal stability analysis of light jets
- Modelado y simulación del calentamiento de aire en invernaderos utilizando colectores solares planos
- Modeling and experiments of energy storage in a fluidized bed with PCM
- Modeling of the heat transfer coefficient in fixed and fluidized beds with PCM
- Multicontinua description of spray diffusion flames in counterflow mixing layers
- Numerical and experimental analyses of the translation of bubbles due to non-spherical interface deformations
- On the generation of mini-clusters of microbubbles using water electrolysis
- On the influence of GDL compression on the performance of liquid-feed DMFCs under low cathode flooding conditions
- PIV error sensitivity analysis for free turbulent flow characterization
- Physics of beer foaming-over
- Physics of bubble generation. A specific procedure for the mass generation of monodisperse, micron-sized coated bubbles
- Quantum Analogies in the Interaction between Acoustic Waves and Bubble Clouds
- Recent advances in x-ray tomography of fluidized beds
- Single camera 3-D shadowgraphy system for droplet sizing
- Stability of the laminar wake behind spinning axisymmetric bluff bodies: sensitivity and control
- The directly air-cooled LiBr/H2O absorption system: an opportunity for small machines
- The role of separation of scales in the description of spray combustion
- Theoretical model of a direct-expansion solar assisted heat pump: Model results to constant and variable condensing temperature
- Transition to jetting in a dripping faucet at high Bond numbers
- Wall conduction effects in laminar counterflow parallel-plate heat exchangers with small scale wall corrugations
- Wall conduction effects in laminar counterflow parallel-plate heat exchangers with small-scale wall corrugations
Projects
- Acumulación de electricidad por absorción combinada con dispositivo convertidor de energía de las olas para la optimización energética (WEGSES-Wave Electric Generator With Sorption Energy Storage)
- Experimental investigation to explore the feasibility of a new non-invasive technique to measure the absolute, or reference, pressure inside a porous medium (Study Agreement Ref. FR00006995)
- Máquinas de refrigeración por absorción miniaturizadas de alta eficiencia utilizando tecnología de membranas
- Revisión técnica del catálogo de equipos de laboratorio de Gunt
- Tecnologías energéticas térmico-solares y de aprovechamiento de calores residuales a baja y media temperatura integradas en la red electrica